A spirit-based colour intensifier that impregnates deep into the stone and helps protect it from water-based staining and general dirt. For use on textured granite, sawn limestone, slate, yorkstone, sandstone, terrazzo and concrete slabs
Description:
A special product from the Lithofin range for marble, natural and artificial stone. It is a silicone-based, ready-to-use impregnator, with special colour-intensive additives which are soluble in an organic solvent. Lithofin MN Colour Intensifier penetrates the surface. It is water-repellent and intensifies the colour. The water-repellent effect reduces the tendency to collect dirt and makes maintenance easier. Water vapour permeability is retained so that no surface film is formed.
Field of application and suitable surfaces:
Particularly suitable for colour enhancement on walls and floors, steps, house floors, terraces etc. which appear colourless, or have to adapt in colour to a polished surface. Lithofin MN Colour Intensifier is suitable for porous, absorbent natural stone with rough, flamed surfaces such as granite, gneiss, porphyre, bricks, slates, sandstone slabs, natural stone like terrazzo and concrete etc. This product can be used for both indoor and outdoor applications. If the flooring or walling application requires a grease-repellent Lithofin MN Colour Intensifier can be applied prior to Lithofin MN Stain-Stop. Lithofin MN Stain-Stop can be applied between 3-4 hours after Lithofin MN Colour Intensifier.
Please note:
Glass, polished surfaces, plastics etc. must be protected against splashes. Do not apply in direct sunlight or in a temperature exceeding 25°C. The application tools can be cleaned using thinner or white spirit.
Durability:
inside the effect is practically unlimited with correct care. Outside, the colour enhancement effect remains for several years according to the surface and weather. The protective effect is retained for 5-7 years.
Directions for use:
The surface should be absorbent, clean and dry. It is not suitable for highly polished surfaces. If in doubt, apply to test areas. Apply Lithofin MN Colour Intensifier thinly and uniformly with a roller or brush or builder's sponge. In the case of strongly absorbent surfaces, repeat the process twice. On less absorbent surfaces where gloss is formed, remove any residue with a cloth.
Coverage:
about 5-10m²/L, depending on surface porosity.
Lithofin MN Colour Intensifier
Drying time:
about 30-40 minutes
Storage:
Keep cool and dry.
Shelf life: Several years
